Required Tools
In addition to your normal every day hand tools in both SAE and Metric you will need the following to do this installation.
- Air Compressor
Pneumatic Air Chisel
Air Chisel Bit, Round = 0.460 ? 0.475-inches in diameter
?-inch NPT Thread Tap
Hand Punch
Grinder
Fuel Line Disconnect Tool
Electric Drill and Bits
Soldering Iron
Torx T-25 bit
1 and 1/16-inch Open End Wrench
?-inch Nut Driver
Fuel Pressure Gauge
Engine Compression Gauge
Allen Wrenches in these sizes; ?-inch, 5/32-inch, 5MM, and 6MM
Needed Supplies
- Sensor Safe Clear Silicon Sealer (RTV)
Loctite ? Medium Strength, Blue
Thread Sealing Compound or Teflon Tape
Solder
6-inch of 1/8-inch Wire Heat Shrink Insulation
18-inches, Red 18 gauge insulated wire
18-inches, Black 18 gauge insulated wire
Optional Items I used
- 1 Steel Hose Barb for 3/8-inch hose with ?-inch NPT threads
1 Throttle Body Gasket (Napa Part # G33268 or Mopar # 53007543)
4 extra 1.5-inch stainless steel hose clamps. (Worm gear type.)