Quote:
Originally posted by TJRON
That's nice Blaine.
I haven't had a tight situation on the trail with mine yet but I do remember Jim B using a lot of rods to do the same track bar repair on my Jeep so he could reach up there.
What I had been thinking was adapting the welding whip to the snout of the spool gun. It might still all fit in compact Ready Welder case? What do you think?
|
You describe what I just did. I adapted the whip to the snout of the spool gun. If it's not removeable like mine is, you will ruin the whip by trying to roll it up that tight. The hard part is cutting up the whip to make the trigger on the mig whip run the spool gun.
The other issue is the drive assembly in the spool gun will only reliably feed the wire through about 6' of whip and that's with a modified Tweco .045 contact liner.