|
From Jeepz.com
I managed to find this brake bleeding kit in a local
parts store. It is a pretty simple setup that you should be
able to make yourself. It has a hose that goes into a jar of
brake fluid.
First, take off the master cylinder lid, and top it
off with fluid
locate the bleeder valve, and loosen it with a
wrench.
Attach a hose to the valve and fully open the valve.
I put a coffee can under everything to catch any
spilt brake fluid. You simple pump the brakes until there
are no more bubbles visible in the clear tube, then run over and
tighten the bleeder valve up again
How-to Tools
Show Printable Version
Email this Page
|