|
|||||||
| Black Label Have you been treated good or bad? Share your story. This is the place to praise or shame |
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
04-08-2002, 12:09 PM
|
|||
|
|||
|
D35 Rear axle outboard bearings....
The D 35 has the stupidest bearing design ever on the outer bearings... the axle is the bearing race.... so if your bearings go bad they gouge your axle shafts... can't the bearings be cartriges pressed onto the shaft like a 9".... that sure would make pulling those suckers easier as welll.... grrrrr.....
Gotta go home and try the puller i made today at work! Tim 94 ZJ I-6 Laredo, np231, 7" custom Long Arms, 33x12.50 TSL Radials, lots of other stuff
__________________
94 ZJ I-6 Laredo, np231, 7" custom Long Arms, 36x12.50 TSLs, 9" HP D44, 4.88s, Spool, miller locker 
|
|
#2
05-07-2002, 07:46 PM
|
|||
|
|||
|
Most if not all c-clipped rears work that way. I toasted a shaft on my 8.8 back when I was racing my Mustang. It did just that, bearing went bad and killed the shaft. Hey another reason to stick with a 9" instead of the 8.8".
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Should I buy this d35 axle? | steelman | Jeep Friends Forum | 11 | 06-15-2007 08:23 PM |
| TJ Rear Axle Question | bart | Jeep Friends Forum | 8 | 06-19-2003 08:06 PM |
| Rear axle suggestion? | bart | Technical Forum | 0 | 06-16-2003 08:13 AM |
| Rear axle bearings and retainer part #s? | ChrisK | Technical Forum | 2 | 01-31-2003 04:33 PM |
| Dana 44 Axle Bearings Fit? | TJRON | Technical Forum | 3 | 10-15-2001 10:08 PM |
Linear Mode
