|
Fabrication and Metalworking Get welding advice, discuss different alloys, share pictures of your first fabrication attempts, as well as welds you are especially proud of |
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
Buying the wire to make an extension cord for the welder
I can't seem to find 8/2 or even 10/2 wire with the usual rubber sheath around it to make a short 10'-15' extension cord for my 220v welder, and I don't want to use Romex. I've called a couple welding shops and they sell complete extension cords for well over $100 but I'm not paying that for 15' of wire and two NE50 connectors. I've also checked with Lowes and Home Depot and they of course look at me like I just arrived from Mars. I would even cut the ends off a 220v dryer extension cord and install the right NE50 plug and receptical on it if I could find one longer than 6'.
Where do I buy 8/2 or 10/2 that is covered like an extension cord? I'd rather buy it locally if I can. |
#2
|
|||
|
|||
McMaster-Carr has some in the 10/3 Wire Size.
|
#3
|
|||
|
|||
Thanks Sergey, I was trying to think of McMaster-Carr for some other stuff too so I'll just order it from them at the same time. Thanks!
|
#5
|
|||
|
|||
I believe Airgas sells cable by the foot.
Or you could maybe use some of the stuff sold at RV centers. |
#6
|
|||
|
|||
Airgas only has the single conductor stuff by the foot. If I don't get an answer back from McMaster-Carr soon on if they also sell the NEMA 6-50R and 6-50P connectors I also need, I'll check out my local RV supply shop for some suitable wiring.
|
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Ready Welder | NAILER341 | Buy/Sell Jeep Stuff | 1 | 07-27-2004 01:20 PM |