|
Fabrication and Metalworking Get welding advice, discuss different alloys, share pictures of your first fabrication attempts, as well as welds you are especially proud of |
|
Thread Tools | Rate Thread | Display Modes |
#1
|
|||
|
|||
Fabricating a 4 link
Since the body tub is off the frame on my CJ, I want to take advantage of the time to fabricate a 4 link suspension for the rear and push the axle back 10" (The gas tank is being replaced by a fuel cell in the bed so it won't be in the way).
I remember reading a series of articles in Peterson's on the best way to do it but I can't find my copies. Does anyone have copies they can scan and email or otherwise get to me? Does anyone have any other resources that would be helpfull in designing my suspension?
__________________
1977 Cherokee: 360/TH400/QT/D44/D44 - Beavis 1984 CJ7: 401/SM465/Atlas/D44/9" - In progress 2004 Pontiac GTO: LS1/T56/M80 - My Free Gear Ratio Calculator (In Metric Too) |
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Bilstein 7100- Ford shock mounts- RE 3 link | TJeeper | Technical Forum | 3 | 07-29-2006 09:42 AM |
One upper link on the front. | dennisuello | Technical Forum | 1 | 03-28-2006 10:30 AM |
3 link calculator (plus panhard) | Joel77 | Technical Forum | 11 | 02-21-2006 07:45 PM |
4 link with Airshock ideas | Matt Pascoe | Technical Forum | 5 | 11-23-2004 01:43 PM |
Running a three link with a Dana 30 front and the cast pumkin mount? | chadjans | Jeep Friends Forum | 2 | 06-21-2003 02:50 PM |