|
|||||||
| Technical Forum The main forum for jeep related discussions. Mechanically Inept... |
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
02-17-2004, 05:21 AM
|
|||
|
|||
89 YJ Dana30 Truetrac
OK. I am in the middle of changing gears to 4.10 in the front. We did the rear last week. Piece of cake?. Tonight we began the front. I am also installing a TrueTrac in the stock front Dana30.
Question?? When we were checking things out on the floor we noticed that the front TrueTrac did not have a "window" to put the retaining "c" clip on the inner right shaft (I have the stock split right shaft). I verified that I had the correct TrueTrac part number. After evaluating the situation looks like if we put a ~.250 thick spacer in the TrueTrac (there is a ~.125 washer in the middle of the TruetTrac) things should work OK. This should put the inner axle shaft were it is suppose to be. Any suggestion? Is there an aftermarket spacer? Thanks 
__________________
4x4david 
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Oops ... I did it again (Dana30 r&p) | Iceman | Jeep Friends Forum | 11 | 06-01-2005 02:07 PM |
| ZJ Dana30 rotors same as TJ? | Iceman | Jeep Friends Forum | 4 | 05-23-2005 08:46 PM |
| 89YJ Dana30 TrueTrac | 4x4david | Technical Forum | 0 | 02-17-2004 05:18 AM |
| Synthetic oil in TrueTrac... yea or nay? | Handlebars | Technical Forum | 1 | 11-27-2002 10:45 AM |
| TJ Dana 35c, 4.10 gears, Truetrac LSD, near San Diego. | Jerry Bransford | Buy/Sell Jeep Stuff | 0 | 10-10-2002 10:53 PM |
Linear Mode
