|
|||||||
| Fabrication and Metalworking Get welding advice, discuss different alloys, share pictures of your first fabrication attempts, as well as welds you are especially proud of |
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
01-10-2007, 09:47 PM
|
|||
|
|||
|
tube fenders
Poison Spyder has nothing over me.
Took a set of tube fenders that were home made and on 3 other CJ's. They had been rolled once, and flopped once; so needed major rehab work. This is the end result. Lots of blood, sweat and Gatorade in these. Probably been easier to start from scratch, but I am happy with them. Oh, and for you bedspring type folks-those are cut up TJ flares. I am not too proud to use any Jeep parts on the CJ. 
|
|
#2
01-11-2007, 06:09 AM
|
|||
|
|||
|
Nicely done, IMO. They look good.....and recycling is one way to do it for sure!
|
|
#3
01-11-2007, 08:29 AM
|
|||
|
|||
|
Nice work Don.
__________________
Jeff
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Tube Fenders | Jonabin | Technical Forum | 14 | 03-26-2007 06:46 PM |
| Tube Fenders | H8PVMNT00 | Technical Forum | 18 | 10-10-2005 08:34 PM |
| Fabbing Tube fenders | eurobob | Jeep Friends Forum | 3 | 04-14-2004 08:20 PM |
| Metal Fusion (Tube Fenders) | igofshn | Jeep Aftermarket Companies | 0 | 02-03-2004 02:20 PM |
| Tube fenders | igofshn | Jeep Friends Forum | 10 | 02-02-2004 09:18 AM |
Linear Mode
