|
|||||||
| Fabrication and Metalworking Get welding advice, discuss different alloys, share pictures of your first fabrication attempts, as well as welds you are especially proud of |
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
04-20-2007, 09:16 PM
|
|||
|
|||
|
All just guesses.
 The second (lower) bead could have been tighter against the first bead & overlapped more. The right end of the third bead is a little too flat, but the left side is at a better angle after ~1/4 of the way across. The right side of the same bead could have been filled more at the end, plus the left end could have started more to the left. The bottom weld has no slag......different machine?
__________________
'91 YJ,4.0, AX-15, SOA +1.5" leafs, SYE, D30/F8.8, 4.56, ARB's, & 3 rug rats! 
|
|
#4
04-21-2007, 12:07 PM
|
|||
|
|||
|
i dont know, but i will tell you that i wish my welds that had something wrong with them looked that good
 outside of that, i would guess that the stacked welds are in the wrong order?
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| practice welds | Tim | Fabrication and Metalworking | 2 | 04-24-2007 07:59 AM |
| Cinder mine closure, Old news, but wrong just plain wrong. | Bruce David | Jeep Friends Forum | 0 | 10-18-2004 01:42 PM |
| Big Welds.....Multipass Too.....No Weave! | Allen | Jeep Friends Forum | 8 | 08-25-2003 07:31 AM |
| Would this be wrong?? | Sephiroth | Jeep Friends Forum | 8 | 06-24-2003 10:24 PM |
| Do you trust welds? | mrblaine | Jeep Friends Forum | 30 | 09-24-2002 08:04 AM |
Linear Mode
