Radiator Drop Down Brackets Needed!

[sethmark]

Help, only you can save blaine from doing unnecessary work! I'm looking for the radiator drop brackets included with Body lifts.

Anyone buy a body lift and motor mount lift at the same time and not use those pieces?



I'll pay!
Seth

[DanB98TJ]

For 1" or 2" BL? I have some that I cut down to work for a 1" BL, and they will be available as soon as I get a chance to install the MMs.

[sethmark]

I don't need a lot of drop... anywhere from 1" to 2" is fine. But I'm wickedly impatient! I need the jeep running......

[DanB98TJ]

PM me your address. I have some camper refrigerator issues to deal with before work tomorrow, but if I can get the MMs in this week I'll mail them to you if you don't find any before then.

[mrblaine]

Oh, those. I think I have some in the garage. About and inch or so, right? I'll look in the am.

We'll see how the magic cabinet fares this time around. Hasn't let me down yet.

[blkTJ]

speaking of the magic cabinet... you never did pick up those washers did you?!?

[igofshn]

I have some in central CA. I'll be seeing Brian (blktj) this weekend and could give them to him.

[mrblaine]

Originally posted by blkTJ
speaking of the magic cabinet... you never did pick up those washers did you?!?

As a matter of fact I did. They just didn't bill you.

[Tim]

have you thought about just re positioning the fan shroud instead of brackets? you can just drill new holes in the shroud or even put in taller motor mounts.

[William]

Go to home depot, buy some bar stock, cut to length, drill and place. Seems easy as I type about it. What could be hard?

[blkTJ]

Originally posted by mrblaine
As a matter of fact I did. They just didn't bill you.

I love that place. If I had a Christmas card list, they'd be at the top.

[blkTJ]

Originally posted by igofshn
I have some in central CA. I'll be seeing Brian (blktj) this weekend and could give them to him.

Blaine, Seth...If I can be of assistance please let me know.

[sethmark]

Originally posted by T.Dome
have you thought about just re positioning the fan shroud instead of brackets? you can just drill new holes in the shroud or even put in taller motor mounts.

Those are lovely, but non applicable suggestions.

See: http://www.jeepbbs.net/forums/showth...5411#post45411

William, its not a question of hard, its a question of expedient. I don't feel like ****ing around with the little stuff anymore. I'm in a get **** done mode.