|
|||||||
| Jeep Friends Forum This is a forum for jeep friends to hang out. For more formal atmosphere hop over to the Technical Forum |
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
03-22-2005, 01:16 PM
|
|||
|
|||
|
Beefing up rear bumper mounting area?
Okay so I am not a welder
 but I opted to add these gusset supports to my new bumper. The factory 1/8" channel did not seem strong enough to me. I realize I must grind off the weld if I want to remove the body bolt but that is no big deal... I am good at grinding  
__________________
Growing old is mandatory. Growing up is optional. 
|
|
#2
03-22-2005, 01:26 PM
|
|||
|
|||
|
I have a similar bracket but without the additional flat extending along the frame. The biggest difference is that I also had a piece of angle welded all the way across the crossmember. My rear bumper is not going anywhere
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Currie Rear bumper and Tailbones install question: | speaceman | Technical Forum | 1 | 10-01-2005 06:04 PM |
| My rear bumper | John | Technical Forum | 7 | 09-13-2005 05:23 PM |
| What's behind the rear bumper guard on '99XJ | kid4lyf | Jeep Friends Forum | 1 | 02-04-2004 09:26 AM |
| Rear Cargo Area Husky Liner Coverage | Allen | Jeep Friends Forum | 3 | 07-21-2003 11:50 AM |
| FINALLY got started on my rear bumper... | DanB98TJ | Jeep Friends Forum | 16 | 07-08-2003 09:29 AM |
Linear Mode
