|
Fabrication and Metalworking Get welding advice, discuss different alloys, share pictures of your first fabrication attempts, as well as welds you are especially proud of |
|
Thread Tools | Rate Thread | Display Modes |
#1
|
|||
|
|||
Draglink & Tierod
I need to upgrade my steering.I have the Terra alum. stuff with the big TRE on a CRD HP60.The jam nuts keep coming loose even with red locktite & the threads are getting hammered in the alum.I was thinking of using 1.5 dom with .250 wall with threaded inserts & the same TRE.Overkill? Bad choice of material? What do you think?I have pics if needed.(large)
__________________
Cactus Kid |
#2
|
|||
|
|||
PM Larry over on JU if he doesn't see it here but he ran into the same problem as you with the Teracrap and went to DOM if I recall correctly.
|
#3
|
|||
|
|||
Thanks Robert!
__________________
Cactus Kid |
#4
|
|||
|
|||
Well I finally got all the parts(backordered-wrong stuff sent-yada yada)& pulled the old Terra steering off.The TRE's are fine but the knuckles have some marks in them from being loose at some point. Can this be used? Is it safe? What do you think? Thanks, Bob
__________________
Cactus Kid |
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
WJ knuckle plan? | 02_WHITE_TJ_X | Technical Forum | 23 | 12-03-2003 06:37 PM |
How to tighten nut that connects the tierod and pitman? | LeadFoot | Jeep Friends Forum | 6 | 08-08-2003 05:56 PM |
Complete Currie front-end or just the drag link for now? | Jerry Bransford | Jeep Friends Forum | 7 | 02-09-2003 10:44 AM |
So do you want the draglink and tierod to be parallel? | mudpup | Jeep Friends Forum | 5 | 03-14-2002 06:01 PM |
Got Draglink? | Robert J. Yates | Jeep Friends Forum | 9 | 01-16-2002 05:14 PM |