|
Technical Forum The main forum for jeep related discussions. Mechanically Inept... |
|
Thread Tools | Rate Thread | Display Modes |
#1
|
|||
|
|||
Size of needle type grease fitting in driveshaft
I was lubing the driveshaft yesterday when I noticed one of the needle type fittings missing. Does anyone know off hand what size it is so I can get one on the way home? The shaft is a Tom Wood special, with 1310 u-joints.
Thanks-
__________________
Patrick |
#2
|
|||
|
|||
It is "probably" a 1/4"-28 fitting. I actually had a tierod with an 8mm metric thread. FWIW, I couldn't find any of the needle fittings at my local auto parts store.
Good luck!
__________________
Jeff |
#3
|
|||
|
|||
I couldn't find any needle zerk fittings either. I needed one for my new drag link so I ended up cutting the top of a standard zerk fitting flush with the hex-head and stuffing the threaded portion full of JB-Weld to plug it up. That plugged zerk serves as a plug for daily driving. Then when you need to grease it, remove the zerk-plug and insert a standard zerk fitting for the actual grease job, then you can re-insert the plug.
Tom Wood probably would send you one if you asked him too. |
#5
|
|||
|
|||
Napa had them. He knew exactly what I was talking about, and I ended up buying a few 1310 joints to use as spares.
__________________
Patrick |
#6
|
|||
|
|||
Quote:
|
#7
|
|||
|
|||
Frank (Daless2) sent me this information on the flat zerk fitting...
Here is the info. http://www.mcmaster.com/ The McM-Car Part Number = 10595K14 Description = 1/4"-28 Flush Style Grease Fitting Print catalog page # = 1,984 Cost = $4.55 for a package of 5 |
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Reminder - Grease your driveshaft | TObject | Jeep Friends Forum | 11 | 05-14-2004 05:34 AM |
Blind Zerk Grease fitting?? | H8PVMNT00 | Technical Forum | 6 | 03-19-2004 03:52 PM |
What size is this fitting? | ChrisK | Jeep Friends Forum | 13 | 12-31-2002 05:31 PM |
Where does the grease fitting go? | Stu Olson | Technical Forum | 5 | 08-19-2002 10:23 PM |