|
Technical Forum The main forum for jeep related discussions. Mechanically Inept... |
|
Thread Tools | Rate Thread | Display Modes |
#1
|
|||
|
|||
Valve job
I need to do a lot of work on my Jeep in the VERY near future. New oil seals and ball joints in the axle, radiator hoses, thermostat etc.
While I have the front end off my Jeep I am thinking of re caming it and while I am at it doing a head-valve job. That said, my Jeep has about 80k miles on it, does NOT use any oil and runs fine. The old school in me remembers when by 50k the engine NEEDED a valve job, but times have changed. As for the cam, well it is not a NEED, but rather a: Hmm wonder how this would work. Some will say, 'if it ain't broke don't fix it'. MUCH truth in that but some things require Preventive Maintenance, like radiator hoses etc. Thoughts???
__________________
Don Scottsdale, AZ http://www.savagesun4x4.com visit my forum: all rigs, expedition type travel in the SW and beyond, all are welcome, no cost just friendship... www.savagesun4x4expeditions.com |
#2
|
|||
|
|||
Do the preventative maintenance stuff.
Leave the internals alone. You know a properly maintained 4.0L could easily see 250k or more before needing attention.
__________________
(OlllllllO) Me, Me, Me-It's All About me. But Enough About Me. What About You? What Do You Think Of Me? |
#3
|
|||
|
|||
I agree with Allen, your 4.0L shouldn't even be close to needing a valve job yet. My 4.0L has 174,000 miles on it a valve job is not even close to being on my short list of things to do.
|
#4
|
|||
|
|||
That seems to be the smart money thoughts, thanks, I appreciate it, guess I will pass on the cam/valve job and just stick with other PM efforts.
__________________
Don Scottsdale, AZ http://www.savagesun4x4.com visit my forum: all rigs, expedition type travel in the SW and beyond, all are welcome, no cost just friendship... www.savagesun4x4expeditions.com |
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Tranny coolant line valve question | Jerry Bransford | Technical Forum | 0 | 02-21-2008 01:12 PM |
Turn my welder's main gas valve off? | Jerry Bransford | Fabrication and Metalworking | 10 | 01-01-2007 10:03 PM |
Staun Bead Lock Valve Stem Questions | DC | Technical Forum | 16 | 04-12-2005 04:28 PM |
On Board Fluid (OBF) System - Complete | Daless2 | Jeep Friends Forum | 10 | 12-31-2001 05:54 PM |
Metal valve stem ? | Ace! | Jeep Friends Forum | 7 | 10-27-2001 08:11 AM |