|
Fabrication and Metalworking Get welding advice, discuss different alloys, share pictures of your first fabrication attempts, as well as welds you are especially proud of |
|
Thread Tools | Rate Thread | Display Modes |
#1
|
|||
|
|||
Need any custom laser cut tabs etc?
Within the next few weeks I'll be sending a CAD file to a local laser fab shop to have some 1/4" tabs cut for me.
If any of you guys need some oddball 1/4" steel shapes cut I'd be glad to add it to my order, I'll probably have a minimum order anyways. WJ knuckle spacers come to mind... Matt
__________________
The trouble with common sense is it is no longer common |
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
custom fuel tank/through the floor | dennisuello | Technical Forum | 9 | 09-30-2005 04:57 PM |
Axle truss, coil buckets, Lower control arm tabs on the 8.8 | chadjans | Jeep Friends Forum | 6 | 04-20-2003 04:29 PM |
Where to get CHASSIS TABS for LA's and AXLES? | chadjans | Jeep Friends Forum | 5 | 02-19-2003 11:22 AM |
Custom Wound Coil Springs | Z-what? | Technical Forum | 4 | 05-21-2002 05:07 PM |
Rear Standard Cut D44 and Belly Up? | Ace! | Jeep Friends Forum | 30 | 04-25-2002 06:39 PM |