|
Technical Forum The main forum for jeep related discussions. Mechanically Inept... |
|
Thread Tools | Rate Thread | Display Modes |
#1
|
|||
|
|||
Motor mount dimensions
Could someone with a stock TJ motor mount laying around give me the dimensions of the footprint of the mount, as well as the distance on center between the two fastener locations in the mount? TIA.
|
#2
|
|||
|
|||
The base is 2.280 wide x 4.480 long
The fasteners are stud and hole for a through bolt and are 3.465 on center. The hole is .440 in diameter and the stud is .390 in diameter. That would be a 10 mm bolt and a 11.5 mm clearance hole.
__________________
I am Savvy. |
#3
|
|||
|
|||
Wow, thanks for the precise measurements. Is that buried in the FSM somewhere, or do you have some sort of digital calipers?
|
#4
|
|||
|
|||
Quote:
2.294 wide x 4.486 long 3.465 c to c on the stud to hole stud .390 hole .4395 The digital ones also do mm's, do you need those also? I was trying to figure out why the length changes. It's a two piece mount and the safety cover over the rubber part interfers with the OA dimension. The width changes depending on where you measure it. At one end it is 2.288 to 2.306 in the middle.
__________________
I am Savvy. |
#5
|
|||
|
|||
Thanx, that'll do. |
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
AX15 transmission dimensions and weight? | ausjeep | Technical Forum | 4 | 07-22-2004 02:15 AM |
Dimensions Services | emills | Black Label | 2 | 10-29-2002 01:29 PM |
Factory TJ Dana 35-C and TJ Dana 44 Axle Tube Dimensions. | Daless2 | Jeep Friends Forum | 12 | 02-23-2002 05:47 PM |