|
Technical Forum The main forum for jeep related discussions. Mechanically Inept... |
|
Thread Tools | Rate Thread | Display Modes |
#1
|
|||
|
|||
Puegeot tranny won't go into any gear/stuck in gear?!
I drained the fluid out of it (needed changed), I then proceeded to remove the shifter and pour two quarts of ATF through the top (While the drain plug still removed). I let it set like that for a few days, meant to be overnight to get all of it to drain out but didn'tt get to work on it forawhile.
Worked on it tonight some. I put the drain plug back in, and put in two quarts of pennzoil synchromesh fluid from the top. Bolted the shifter back on and its stuck in gear. Which one I dont know. With the engine off it wont go into gear with the clutch in or out. With the engine running and the clutch in it just wont go into any gear. But it does the slop in it like trannys have when in neutral. However, it only goes to the right. When I let go, it goes to the left and wont move any farther to the left. So its stuck in gear and the shifter moves to the right. I never ran the tranny with no fluid in it. What's going on? Thanks!!!
__________________
My Jeeps suck, but my bikes are pretty cool |
#2
|
|||
|
|||
Re: Puegeot tranny won't go into any gear/stuck in gear?!
Quote:
__________________
I am Savvy. |
#3
|
|||
|
|||
Blaine:
Thanks for the reply. I removed it and installed it numurous times with no success. Excuse the mud, I cleaned it off the best I could before I started to work on it. The shifter slides into the two metal slots perfectly but won't move (same motions as I described previously. The little metal piece on the left hand is a notch into which the shifter slides into perfectly. http://community.webshots.com/photo/...23842396NvUaNK http://community.webshots.com/photo/...23842553hxLXVA Heres the notch into the shifter which the little metal piece on the tranny slides into. http://community.webshots.com/photo/...23842476BuiGnN Thanks!
__________________
My Jeeps suck, but my bikes are pretty cool |
#4
|
|||
|
|||
Blaine you had it right. Theres a bunch of little rails (best term I can currently think of) that all must be perfectly aligned with eachother before it works. Its now working wonderfully.
Thanks for saving me lots of $$.
__________________
My Jeeps suck, but my bikes are pretty cool |
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
HP60 Issues | wildman4x4nut | Technical Forum | 8 | 09-08-2007 01:44 PM |
Gear installs | truckjohn | Technical Forum | 20 | 09-22-2005 06:00 AM |
Sunday Sunday Sunday!!! Tranny Smackdown!!! | sethmark | Jeep Friends Forum | 22 | 10-17-2003 08:06 AM |
ZJ: '94 auto tranny problem | Z-what? | Technical Forum | 6 | 01-06-2002 03:59 PM |
Hey Brad >> Skyjacker versus MOPAR Deep Tranny Pans for Auto TJ's ?? | DC | Jeep Friends Forum | 9 | 09-10-2001 07:11 AM |