|
Technical Forum The main forum for jeep related discussions. Mechanically Inept... |
|
Thread Tools | Rate Thread | Display Modes |
#1
|
|||
|
|||
RE crossmember swap question
Considering options to improve my breakover angle. One thought is to swap the RE crossmember I have (rubicon version) with the "standard" RE TJ crossmember. The swap, IIRC, should gain me about 2" additional clearance.
Does anyone know if the those two crossmembers are interchangeable with regards to mounting bolt pattern?
__________________
pooring money down the Jeep hole... |
#2
|
|||
|
|||
I'm guessing that you mean swap in a pre 2003 RE transfer case/ control arm skid? If so then the answer is no they cannot be directly swapped. However, if you have some welding and cutting skills, then you can of course make the mods. I believe Nth Degree looked into doing this and even made a few prototypes but decided it wasn't cost effective. You may be able to get the drawings from them if you don't want to reinvent the wheel.
Ken
__________________
03' TJ just starting to get broken in... |
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Swap your auto tranny for my 5-speed AX-15 tranny | Jerry Bransford | Swap Meet Area | 1 | 04-03-2007 11:06 AM |
Swap your auto tranny for my 5-speed AX-15 tranny | Jerry Bransford | Buy/Sell Jeep Stuff | 7 | 02-19-2007 04:30 PM |
E-brake cable swap question | troyman | Technical Forum | 1 | 03-10-2006 10:10 AM |
Swap In of a 5.2L Dodge Magnum V8 Engine ? | DC | Jeep Friends Forum | 3 | 09-20-2005 08:16 PM |
engine swap question | wolfos | Technical Forum | 0 | 01-20-2003 09:46 AM |