|
Fabrication and Metalworking Get welding advice, discuss different alloys, share pictures of your first fabrication attempts, as well as welds you are especially proud of |
|
Thread Tools | Rate Thread | Display Modes |
#1
|
|||
|
|||
Welder choice
1st off let me say that I post here because of the wealth of knowledge & experience on this board.I,m new to fabbing & could use some help.I hope to use this to make front tube fenders & rollcage.Plan to use 1in dom for tube fenders & not really sure of what to use for cage.Any input is appreciated. Whoops sorry-can,t post attachments. Will be using a Millmatic 175 MIG-220 volt with shielding gas-is this OK for .125 tubing??
|
#2
|
|||
|
|||
It will be fine.
Practice until you're very good before you start your cage. Allen
__________________
(OlllllllO) Me, Me, Me-It's All About me. But Enough About Me. What About You? What Do You Think Of Me? |
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Hobart 135 Handler MIG Welder | Joe Dillard | Buy/Sell Jeep Stuff | 7 | 08-05-2006 03:12 PM |
your ready welder | NAILER341 | Jeep Friends Forum | 0 | 08-01-2004 09:17 AM |
Ready Welder | NAILER341 | Buy/Sell Jeep Stuff | 1 | 07-27-2004 01:20 PM |
MIG welder for Christmas? | Jerry Bransford | Jeep Friends Forum | 33 | 11-06-2003 09:20 AM |
Advice on buying a welder | Chris L | Jeep Friends Forum | 10 | 10-25-2002 02:40 PM |