|
Jeep Friends Forum This is a forum for jeep friends to hang out. For more formal atmosphere hop over to the Technical Forum |
|
Thread Tools | Rate Thread | Display Modes |
#1
|
|||
|
|||
a spring that's 1" taller than ProComp 4" rear
My Jeep squats on the rear right corner. Before my axle swap I just had a front factory spring isolator on top of the spring, but now I have BTF spring mounts that clamp both ends of the spring, so I cannot use the same method.
I was thinking that finding a 1" taller spring and using it on that corner will work. Anyone know what spring would be roughly 1" taller? |
#2
|
|||
|
|||
A 4.5" RE spring is probably pretty close, it's definitely slightly taller than its advertised 4.5" height.
|
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Rear spring perch (TJ) question | StealthTJ | Technical Forum | 3 | 12-17-2003 08:12 AM |
Project Air Springs ? 97 TJ (large post) | Daless2 | Jeep Friends Forum | 49 | 10-31-2003 08:50 PM |
WTB: Rancho shocks for 4" lift (rear) | William | Buy/Sell Jeep Stuff | 2 | 06-18-2003 09:55 AM |
Sagging pass side rear spring | Ace! | Jeep Friends Forum | 12 | 02-06-2002 08:30 PM |
FS - 4" Procomp springs | Stu Olson | Buy/Sell Jeep Stuff | 0 | 12-12-2001 02:55 PM |