|
Fabrication and Metalworking Get welding advice, discuss different alloys, share pictures of your first fabrication attempts, as well as welds you are especially proud of |
|
Thread Tools | Rate Thread | Display Modes |
#1
|
|||
|
|||
Dry cut saw for steel
Hey guys I just purchased one of these a few months back.
http://www.evolutiononlineshop.com/s...%202%20%20Saw/ Cuts thru steel as if it was wood and much cleaner than abrasive wheels. If your looking at a chop saw I would consider this first. zman
__________________
too many frick'n jeeps, not enough time. |
#2
|
|||
|
|||
Quote:
__________________
I am Savvy. |
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Dry Ice Web Site | TObject | Political Arm Pit and Fool Shed | 2 | 09-15-2010 09:12 PM |
Need any custom laser cut tabs etc? | Matt Pascoe | Fabrication and Metalworking | 8 | 02-03-2005 07:59 PM |
Dana 44 R&P 4.56 std cut | Dan-H | Buy/Sell Jeep Stuff | 0 | 07-25-2002 10:45 AM |
Rear Standard Cut D44 and Belly Up? | Ace! | Jeep Friends Forum | 30 | 04-25-2002 06:39 PM |
How to cut 3/16" or 1/4" steel? | Ace! | Technical Forum | 5 | 01-14-2002 07:38 AM |