|
|||||||
| Fabrication and Metalworking Get welding advice, discuss different alloys, share pictures of your first fabrication attempts, as well as welds you are especially proud of |
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
05-27-2006, 02:13 AM
|
|||
|
|||
|
Critique my welds part 3
Here's a few more pics of some welds I tossed down earlier tonight. The first & second pics are of the same weld.
Comments are welcomed.     This is just some tac welding I did for a saddle I'm making. It might be hard to tell....but there are three pieces of material incorporated into the saddle. Two of which make it look like a piece of channel, but there are actually two pieces of angle iron butted together, one of the pieces is trimmed. Plus the verticle piece. 
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Critique my welds part 2 | Joe Dillard | Fabrication and Metalworking | 45 | 05-29-2006 01:43 PM |
| Big Welds.....Multipass Too.....No Weave! | Allen | Jeep Friends Forum | 8 | 08-25-2003 07:31 AM |
| Allen, mrblain, et al, please critique my welds.... | Ary'01XJ | Jeep Friends Forum | 8 | 07-08-2003 06:40 AM |
| Do you trust welds? | mrblaine | Jeep Friends Forum | 30 | 09-24-2002 08:04 AM |
| ATLAS II with a Dana 30 | Desert Fox | Jeep Friends Forum | 26 | 02-22-2002 07:23 PM |
Linear Mode
