|
|||||||
| Jeep Friends Forum This is a forum for jeep friends to hang out. For more formal atmosphere hop over to the Technical Forum |
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
04-17-2010, 11:21 AM
|
|||
|
|||
|
So...
How many miles does one need to have on a ring and pinion set (4.56) that they installed themselves to consider it a success so they can stop worrying they screwed something up?
 
__________________
(OlllllllO) Me, Me, Me-It's All About me. But Enough About Me. What About You? What Do You Think Of Me? 
|
|
#2
04-17-2010, 03:06 PM
|
|||
|
|||
|
All depends on how paranoid you are.
 After a few thousand miles and a few fluid changes with no metal shavings, chunks, bolts, or anything else stuck to the magnet I was pretty confident I didn't screw things up too badly.
__________________
NOW: 1996 XJ, 4.0/AW4/NP242. 1.5" spacer/shackle lift, 30x9.50's, open both ends  GONE: 1998 TJ, 4.0/5-speed. Currie lift. D44/HP D30, 4.88s, Detroits, Tera 4:1, 2-low. 35" MTRs "The man who loves other countries as much as his own stands on a level with the man who loves other women as much as he loves his own wife." "We can have no "50-50" allegiance in this country. Either a man is an American and nothing else, or he is not an American at all." Theodore Roosevelt
|
|
#3
04-17-2010, 07:24 PM
|
|||
|
|||
|
Down the street 10 yards!
|
|
#5
04-19-2010, 07:48 AM
|
|||
|
|||
|
My shop-installed R&P job lasted six weeks Allen before the rear axle started howling while offroad. They were Spicer gears, the installer (an experienced R&P guy) owned up to the problem likely being installation-related. With your attention to detail however, I'm betting your job will be fine.
|
|
| Bookmarks |
|
|
Linear Mode
