|
Jeep Friends Forum This is a forum for jeep friends to hang out. For more formal atmosphere hop over to the Technical Forum |
|
Thread Tools | Rate Thread | Display Modes |
#1
|
|||
|
|||
guys with swayloks... need some measurements
Could anyone give me a few measurements on their swayloks??
I need to know #1 total Arm length #2 distance from centerline of tube to the outboard measurement of the solenoid
__________________
Fancy Grocery Getter.. |
#2
|
|||
|
|||
My solenoid is located in the engine compartment. I assume you mean the actuator?
I would get the numbers for you but the TJ is 50+ miles from where I am typing. |
#3
|
|||
|
|||
Uh, that is what I mean..
thanks STU
__________________
Fancy Grocery Getter.. |
#4
|
|||
|
|||
In case I get home before anyone provides an answer for you, what is the outboard measurement of the actuator?
The end of the plunger, the end of the air cylinder itself? Let me know. |
#5
|
|||
|
|||
Re: guys with swayloks... need some measurements
Quote:
#1 Total Arm Length = 16-inches (Center line to Tip of Arm #2 center line to near end of air cylinder = 1.5-inches or Center line to far end of air cylinder = 6.0-inches Hope this helps Frank |
#6
|
|||
|
|||
Frank, that is perfect...
Steve is doing up a custom one for my Grand cherokee and I needed him to shorten the arms slightly...
__________________
Fancy Grocery Getter.. |
#7
|
|||
|
|||
Quote:
I have been wanting a swayloc for awhile now. Any chance you could PM the measurements your having steve build out for you |
#8
|
|||
|
|||
Quote:
__________________
I am Savvy. |
#9
|
|||
|
|||
Quote:
|
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
RE 3.5 adjustable arms... measurements for length in rear. | Wind_Danzer | Technical Forum | 3 | 02-09-2005 08:15 PM |
The Guys' Rules | JeepKat | Jeep Friends Forum | 7 | 05-20-2004 08:12 AM |
Ok guys... why is getting flowers from a chick considered "gay"? | Wind_Danzer | Jeep Friends Forum | 35 | 08-04-2003 05:20 PM |
OK guys answer me this.... | Wind_Danzer | Jeep Friends Forum | 40 | 07-26-2003 06:56 AM |
More TJ Factory Axle Measurements D-35c / D44 | Daless2 | Jeep Friends Forum | 1 | 03-26-2002 04:24 AM |