|
Technical Forum The main forum for jeep related discussions. Mechanically Inept... |
|
Thread Tools | Rate Thread | Display Modes |
#1
|
|||
|
|||
Source for tranny mounts
Does anyone know where these rubber mounts are sourced from? It looks like both AEV and 33 Engineering are using the same ones for their TTs. This is from the Offroad Toy Store's website:
__________________
Patrick Last edited by TJeeper; 03-04-2009 at 01:16 PM. Reason: source added |
#2
|
|||
|
|||
I believe Grainger Has them in two different stiffness's.
|
#3
|
|||
|
|||
I couldn't find them in the Grainger catalog, but I did find something similar in the McMaster-Carr catalog. This is from the online catalog, page 1359 (I couldn't figure out how to link to it).
Unfortunately I haven't a clue which one to order. I can measure the static weight of the tranny with it installed, but I am not sure if this would be appropriate in this application. Anyone have a suggestion?
__________________
Patrick |
#4
|
|||
|
|||
Looking at a flat skid? I have the Nth kit with those and I alway find it a PITA when I got to take the skid plate off.
zman
__________________
too many frick'n jeeps, not enough time. |
#5
|
|||
|
|||
No. I am installing an AW4 and using the stock mount puts the transfer case higher off the skid than I need. Since I was starting to have the driveshaft bind at full droop with my old driveshaft (the AW4 is 1" longer than the AX15) I wanted to get the angle down as low as possible.
I ended up going another route using 1/4" plate and poly bushings. This puts the transfer case about 3/16" above the crossmember.
__________________
Patrick |
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
solid body mounts | dennisuello | Technical Forum | 13 | 02-06-2007 09:42 PM |
42" crt, 37" crt, crt wall and ceiling mounts | chef | Buy/Sell Jeep Stuff | 3 | 06-21-2006 04:00 PM |
I need Stock TJ Door Mirror Mounts and Stirrups | Daless2 | Jeep Friends Forum | 8 | 06-01-2006 07:17 PM |
Motor Mounts | TObject | Jeep Friends Forum | 7 | 11-02-2003 06:49 PM |
Raised Motor Mounts ? | Ace! | Technical Forum | 18 | 07-23-2001 04:57 PM |