|
Jeep Friends Forum This is a forum for jeep friends to hang out. For more formal atmosphere hop over to the Technical Forum |
|
Thread Tools | Rate Thread | Display Modes |
#1
|
|||
|
|||
Need some help with a Master Cylinder problem
I am doing a rear disc, master cylinder and prop. valve swap. I started to bench bleed the MC. All was seeming to go well until I noticed brake fluid seeping out from under the piston. It doesn't seem to be a lot. But it also isn't getting any harder to press in the piston. I have two bleeder valves, with hoses, running into the top of the MC. I haven't gotten any more air out of them for awhile. Does this mean that the MC has a leaking seal? That would mean that this brand new MC is bad? Its out of a Dodge 3500 if that makes any difference?
Thanks
__________________
00 TJ 60 front ARB 5.13 70 rear Detroit 5.13 Atlas 4.3 39.5 Irok's |
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
The power of the internet | mrblaine | Jeep Friends Forum | 20 | 09-11-2006 09:47 AM |
Brake booster and master cylinder off a Commanche | xjacker | Technical Forum | 2 | 08-10-2004 12:25 PM |
How-To Convert an Ox Locker to Air Operations | Daless2 | Jeep Friends Forum | 10 | 08-29-2003 06:08 PM |
Dodge 3500 Master Cylinder Installed | underDAWG | Jeep Friends Forum | 12 | 05-06-2003 04:24 PM |
Bad master cylinder or vacuum booster? | ChrisK | Technical Forum | 12 | 12-21-2002 01:00 PM |