|
Fabrication and Metalworking Get welding advice, discuss different alloys, share pictures of your first fabrication attempts, as well as welds you are especially proud of |
|
Thread Tools | Rate Thread | Display Modes |
#1
|
|||
|
|||
Rear 4 link, TJ D44
I'm going to be adding upper long arms to my rear factory D44 and I need some ideas for an upper truss/link mount.
I seen the Blue Torch Fab truss kit, but that's a bit expensive. I think I can build one that's strong enough, but not sure on the design. Attaching it to the diff cover looks to be a pain in the ass for making one. Is there a better way to get it solid around the top of the cast center chunk?
__________________
Got Wheelin'? |
#2
|
|||
|
|||
Re: Rear 4 link, TJ D44
Quote:
__________________
I am Savvy. |
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Warn rear Full-Floater axles with Disc Brakes for D44 | DRIVESHAFT | Buy/Sell Jeep Stuff | 0 | 07-17-2005 08:42 PM |
Any failures with FT rear 3 link | RIPPN TJ | Technical Forum | 8 | 12-02-2004 08:40 AM |
Warn Full Floater on XJ d44 rear... | Kris | Technical Forum | 1 | 09-04-2003 07:37 PM |
Rear Standard Cut D44 and Belly Up? | Ace! | Jeep Friends Forum | 30 | 04-25-2002 06:39 PM |
Will RE's front axle bracket/truss fit over a rear D44?? | Bushwhacker | Jeep Friends Forum | 0 | 09-16-2001 02:22 PM |