|
Jeep Friends Forum This is a forum for jeep friends to hang out. For more formal atmosphere hop over to the Technical Forum |
|
Thread Tools | Rate Thread | Display Modes |
#1
|
|||
|
|||
Metal Fab shops with Brake press capabilities??
Guys, I am looking for a local So.CAL metal shop that do some brake press jobs for me.
Any suggestions??? I have a piece of 3/8" 6061 I need to have bent for my skid place on my ZJ.. thanks for any input.. Michael
__________________
Fancy Grocery Getter.. |
#2
|
|||
|
|||
Re: Metal Fab shops with Brake press capabilities??
Quote:
Most stuff in 6061 is cut and welded at the right angles. How many bends and what angles?
__________________
I am Savvy. |
#3
|
|||
|
|||
Blaine 2 bends on each side, one at a 15 degree angle and the other at a 75 degree from the 15 degree angle, basically to make a 90 on the ends.
shaped kinda like this. do you think this will be a problem???? thanks for the help Blaine
__________________
Fancy Grocery Getter.. |
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
The power of the internet | mrblaine | Jeep Friends Forum | 20 | 09-11-2006 09:47 AM |
How can just changing brake pads cause a low pedal? | Jerry Bransford | Technical Forum | 7 | 12-04-2005 10:25 AM |
WJ Steering and Brakes are done | MJR | Jeep Friends Forum | 8 | 11-11-2002 11:42 PM |