|
Fabrication and Metalworking Get welding advice, discuss different alloys, share pictures of your first fabrication attempts, as well as welds you are especially proud of |
|
Thread Tools | Rating: | Display Modes |
#1
|
|||
|
|||
Custom 6061 Weld Cart
I don't remember if I posted this here or not, but I made a custom weld cart to hold our XMT 465 multi process power source and S-74DX wire feeder.
Before photos..... Initially it looked goofy, but I had a long term plan firmly in place and I am VERY happy to say that it is finally complete. One very important thing I have learned in building custom "stuff" ahead of time is that published dimensions by the manufacturer are guestimates at best. It really is best to wait until you have the product in hand. As such, the cart is not perfect, yet even so I don't think I could be any happier with how it turned out. Finished version..... I am really proud of how this turned out.....best estimate is around 20k in equipment.
__________________
(OlllllllO) Me, Me, Me-It's All About me. But Enough About Me. What About You? What Do You Think Of Me? |
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Solution To The Problem? Custom Belt Guard | Allen | Fabrication and Metalworking | 0 | 08-30-2008 04:16 PM |
Are You Running the Right Contact Tip? | Allen | Fabrication and Metalworking | 3 | 01-22-2008 07:33 PM |
My first weld | StealthTJ | Jeep Friends Forum | 6 | 07-15-2003 09:23 AM |
Cast Steel | Allen | Jeep Friends Forum | 4 | 07-07-2003 03:34 PM |
Custom Wound Coil Springs | Z-what? | Technical Forum | 4 | 05-21-2002 05:07 PM |