|
Fabrication and Metalworking Get welding advice, discuss different alloys, share pictures of your first fabrication attempts, as well as welds you are especially proud of |
|
Thread Tools | Rate Thread | Display Modes |
#1
|
|||
|
|||
Reverse engineering fillets
I am designing a part that is supposed to snap on top of somebody else’s part. The somebody else’s part has fillets (rounded edges).
What’s a good way for me to manually reverse engineer the fillets on somebody else’s part? Is there, perhaps, a set of measuring templates available, similar to those used to measure threads pitch? |
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
D30 front diff - reverse cut or not? | kid4lyf | Technical Forum | 1 | 01-14-2004 08:50 AM |
WTB 3.73 reverse cut R&P for HP30 | kid4lyf | Buy/Sell Jeep Stuff | 2 | 01-14-2004 08:34 AM |
Question on whether to reverse my tires or not... | Jerry Bransford | Jeep Friends Forum | 5 | 10-12-2003 06:00 PM |
To reverse, or not to reverse... | Kris | Technical Forum | 1 | 06-30-2003 01:33 PM |